Is there any workaround to this?

Discussions about rSAP, about this board and whatever is related.
Post Reply
sinek
Posts: 5
Joined: Thu Oct 15, 2015 4:39 pm

Is there any workaround to this?

Post by sinek » Thu Oct 15, 2015 4:52 pm

Hello,
I've installed rSAP on my Jiayu S3 phone (Android 5.1.1 on a MTK6752 chipset) and had no problems, but whenever I open the SIM access app and grant root permissions I got this message:
Image

The car detects the phone and "connects" to it after introducing the right PIN but after that the phone suddenly disconnects and the car starts searching again for a phone. Is there any way I can solve this or it's something that requires an app update? Would this program work on a Lenovo K3 Note (same chipset but android 5.0)?

I hope I posted this message on the correct forum section.

Thank you very much.

admin
Site Admin
Posts: 4126
Joined: Wed Mar 23, 2011 4:12 pm

Re: Is there any workaround to this?

Post by admin » Fri Oct 16, 2015 11:25 am

You should run the additional installer software.

sinek
Posts: 5
Joined: Thu Oct 15, 2015 4:39 pm

Re: Is there any workaround to this?

Post by sinek » Fri Oct 16, 2015 5:07 pm

admin wrote:You should run the additional installer software.
Thanks for answering. Are you refering to the "Bluetooth SIM Access Install" app? Because I already installed that without any trouble but I still got the "error" message on the "Bluetooth SIM Access (Trial)" app.

admin
Site Admin
Posts: 4126
Joined: Wed Mar 23, 2011 4:12 pm

Re: Is there any workaround to this?

Post by admin » Sat Oct 17, 2015 10:55 am

Sorry, I didn't pay attention to your processor... MTK6752 is a 64 bit CPU, my app doesn't work on these. I hope I can fix it, but currently I'm struggling with strange problems.

sinek
Posts: 5
Joined: Thu Oct 15, 2015 4:39 pm

Re: Is there any workaround to this?

Post by sinek » Sat Oct 17, 2015 12:40 pm

Oh ok. No problem then. Thank you for your time. :)

Post Reply

Return to “rSAP General”